By buying this product you can collect up to
66
points.
Your cart will total 66
points that can be converted into a voucher of
€6.60.
ALEXIT® BladeRep Profile Filler 3K is a solvent free, three-component, fast drying polyurethane filler designed to be used for filling and fairing on GRP substrates.
ALEXIT® BladeRep Profile Filler 3K is a solvent free, three-component, fast drying polyurethane filler designed to be used for filling and fairing on GRP substrates.
ALEXIT® BladeRep Profile Filler 3K is designed for filler repairs of non-structural imperfections in wind turbines. It can be used instead of two component BladeRep Profile Filler 3 outty when faster drying is required.
ALEXIT® BladeRep Profile Filler 3K is supplied in gray. Its hardener is black and its activator is green.
| Mixing Ratio* | 4:1 |
| Pot Life | 5 - 10 min at 23° C (73° F) |
| Application | by putty knife |
| Coverage | 1.2 m² @ 500 µm or 13 sqf @ 20 mil |
| Drying time before sanding | until 1 hour |
| Temperature | 10° C (50° F) |
23 °C (73 °F) |
30°C (86 °F) |
| % ratio of Activator 3K for a pot life of 5 - 10 minutes |
2 % | 1% | 0,3 % |
| Drying time before sanding | 60 minutes | 60 minutes | 60 minutes |
Filler 3K (20 kg) + Hardener 3K (5 kg) + Activator 3k Green (2 x 0.5 kg = 1 kg)
Some products will be considered dangerous goods (ADR) when their container exceed certain amounts. ADR products must be transported by special transport agencies, such as DACHSER or TXT.
* The following products will be considered ADR (Dangerous Goods) when their container EXCEED the values shown in the table below. Products of equal or smaller size than those shown will not be considered ADR, so they may be transported also by SEUR/DPD and GLS.
____________________________________________________
PRODUCT
Polyvinyl and Isopropyl alcohol ................................................ 1 L
Ethylmethylketone / Methyl ethyl ketone ................................... 1 L
Acetone .................................................................................... 1 L
Methyl ethyl ketone Peroxide (X-8 MEKP Catalyst) ...................125 ml
Liquid Amine or Liquid Polyamide (Epoxy Resin Hardener) ....... 5 L
Resins, Top Coats and Gel Coats ................................................ 5 L
Paints ......................................................................................... 5 L
Styrene and MW Paraffin Solution .............................................. 5 L
_____________________________________________________________
If you have selected a product whose container size is considered ADR and you choose SEUR/DPD or GLS as carrier, those ADR products will be transferred into smaller containers to not breach the European Agreement concerning the International Carriage of Dangerous Goods by Road. That is, if you order a 25 kg resin drum and you select SEUR/DPD or GLS as carrier because you need the products sooner, the resin will be supplied in 5 containers of 5 kg each and its catalyst will be supplied in 5 containers of 100 g. This exception is not applicable to peroxides.
In any case, drums bigger than 25 kg must be shipped by TXT or DACHSER.
* Shippings to Portugal will be always carried by Torrestir
Cookie preferences
Español
Français
Deutsch
Italiano
Português
